Engineering, 11.10.2019 04:20 kataldaine

Abattery weighing 0.525 lb can store 30.8 kcal of electrical energy. what is the energy density of the battery in wh per kg? give your answer to an accuracy of 3 significant figures.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

Engineering, 06.07.2019 04:20

An insulated tank truck containing 50,000 pounds of double-distilled, deionized water at 30 °c is pumped into a closed, refrigerated storage tank maintained at 5 °c in a facility located on top of mount mitchell, north carolina (elevation 6,684 feet & average july temperature of 84 °f). a)-determine the volume of the storage tank required to hold the purified water. b)- determine the initial and final pressure differences that must be overcome by a liquid pump assuming the storage tank initially contains air at 5 °c. assume the air is slowly bled out of the storage tank during the water transfer c.) during a routine operation today, the tank is slightly ruptured by a stainless steel pipe and a water acrosol of droplets begins to spray out of the storage tank. state all assumptions and determine the internal pressure within the water droplets produced

Answers: 1

Answer

You know the right answer?

Abattery weighing 0.525 lb can store 30.8 kcal of electrical energy. what is the energy density of t...

Questions