subject
Engineering, 13.10.2019 17:30 miamassimino

Risk assessment

section 1

produce a short report on how to undertake a risk assessment. (1000 words, must include references, text and images)

section 2

undertake a risk assessment using the following information for the work item described.
•part of the roadway outside the construction site has become damaged by the excavation lorries. it requires to be repaired in order to prevent the closure of that entrance onto the site by the local authority highways department.

•an emergency repair is proposed with quick setting concrete, but the roadway will require closure for 12 hours during this work.

•the work will be undertaken using a wheeled excavator, two ground-workers, a floor saw and three bags of quick setting concrete, along with a traffic lights control, cones and ensure that you follow the 'five steps to risk assessment')

section 3

justify the contents of a risk assessment you carried out in section 2, include you're justification for decisions made in terms of the consequences of risk, based on a clear definition of what is meant by reasonably practicable'. (500 words)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
You know the right answer?
Risk assessment

section 1

produce a short report on how to undertake a ris...
Questions
question
Social Studies, 11.04.2020 21:29
question
Mathematics, 11.04.2020 21:29
question
Mathematics, 11.04.2020 21:29
question
Mathematics, 11.04.2020 21:30
Questions on the website: 13722361