Engineering, 14.10.2019 18:00 rmathias485

A4.2 l spark ignited v6 engine operates on a four-stroke cycle at 4200 rpm. the compression ratio is 10.5, the length of the connecting rod is 17.5 cm, and the engine is over square (with bore-to-stroke ratio of 1.3).at this speed, combustion ends at 15° atdc. calculate: a. cylinder bore and stroke length, b. crank offset, c. average piston speed, d. clearance volume of one cylinder, e. total volume of all cylinders at bdc. f. piston speed at the end of combustion, g. distance the piston has traveled from tdc at the end of combustion, h. volume in the combustion chamber at the end of combustion.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

A4.2 l spark ignited v6 engine operates on a four-stroke cycle at 4200 rpm. the compression ratio is...

Questions