Engineering, 16.10.2019 06:20 neariah24
You use your finger to tighten a 3/4 10 unc screw. what's the circumference of the effort force?
what's the ideal mechanical advantage of the screw?
the input gear has 44 teeth, the ideal gear has 22 teeth, and the output gear has 10 teeth. what's the ratio gear?
if the input gear is spinning at 30 rpm, how fast is the output gear spinning?
Answers: 3
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You use your finger to tighten a 3/4 10 unc screw. what's the circumference of the effort force?
Mathematics, 27.06.2019 11:30
English, 27.06.2019 11:30
Health, 27.06.2019 11:30
English, 27.06.2019 11:30
Mathematics, 27.06.2019 11:30
Social Studies, 27.06.2019 11:30
Mathematics, 27.06.2019 11:30
English, 27.06.2019 11:30