Engineering, 21.10.2019 19:20 ranmmm
Two steel shafts (g = 77.2 gpa) are connected to a coupling disk b and to fixed supports at a and c. shaft bc is solid, while shaft ab is hollow with an inner diameter of 25 mm. take t = 1.5 kn·m.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 19:10
Aplate of dimensions 3 m x 3 m is placed 0.37 mm apart from a fixed plate. the plate requires a force of 2n to move at speed of 45 cm/s. evaluate the viscosity of the fluid in between the plates
Answers: 3
You know the right answer?
Two steel shafts (g = 77.2 gpa) are connected to a coupling disk b and to fixed supports at a and c....
Questions
Geography, 17.05.2021 17:50
Advanced Placement (AP), 17.05.2021 17:50
Mathematics, 17.05.2021 17:50
Health, 17.05.2021 17:50
History, 17.05.2021 17:50
Mathematics, 17.05.2021 17:50
Mathematics, 17.05.2021 17:50
Mathematics, 17.05.2021 17:50
