subject
Engineering, 22.10.2019 09:00 peralesdavid34

What cause the differences between simulation and measurement result of the voltage gain of multistage amplifier?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
question
Engineering, 06.07.2019 04:10
Areheat rankine cycle operates with water as the working fluid. steam enters the first turbine at 8 mpa and 450°c and exits at 0.8 mpa. it is then reheated to 400°c before entering the second turbine, where it exits at 10 kpa. if the amount of work into the pump is 8.04 kj/kg and the net work per cycle produced is 1410.25 kj/kg, determine the thermal efficiency of the cycle.
Answers: 3
question
Engineering, 06.07.2019 04:20
Two microscope slides are placed horizontally, one on top of the other, with a drop of a dishwashing liquid between them. the gap between the slides is 1 mm. a machine pulls the top slide to the right with a velocity of 0.15 millimeters per second while the bottom slide is held stationary. a stress gage indicates that a shearing stress of 0.5 pa is required to pull the top slide with this velocity. if the dishwashing liquid adheres to both slides during this process, what is the viscosity of the liquid? specify whether your answer is dynamic or kinematic viscosity, and use appropriate units.
Answers: 1
You know the right answer?
What cause the differences between simulation and measurement result of the voltage gain of multista...
Questions
Questions on the website: 13722363