Engineering, 23.10.2019 04:00 deonharris18

The resistors in the circuit below have the following values: r1 = 7.50 ω, r2 = 7.00 ω, and r3 = 3.90 ω. the two batteries each have a voltage of 3.00 v. a circuit consists of three vertical wires connected at the top and bottom to each other. the left wire contains a resistor labeled r_3. the center wire contains a resistor labeled r_2. the right wire starts at the bottom with a battery labeled emf 2 with its negative pole pointing towards the top, which is then connected to a resistor labeled r_1 which is then connected to the positive pole of a battery labeled emf 1. the negative pole is then connected to the top connection point of the three wires. (a) find the current in through r3. a (b) how much power do the batteries deliver

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer

Answers: 1

Answer

You know the right answer?

The resistors in the circuit below have the following values: r1 = 7.50 ω, r2 = 7.00 ω, and r3 = 3....

Questions