subject
Engineering, 23.10.2019 17:00 tylerkitchen44

Suppose you are looking at the bus routes for chapel hill. it is important that buses arrive on time, and not run late or come too early. you investigate one of the routes and take a 'sample' of 15 circuits, monitoring the time it takes for a bus to complete one full cycle of its route. the mean time to complete the route based on this information was 55 minutes, with a sample standard deviation of 10 minutes. the bus is supposed to take 60 minutes to complete its route. you want to know whether the bus route is completing its route on time with 95% confidence. (assume normally distributed times) construct a null and alternative hypothesis that represents this situation.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
You know the right answer?
Suppose you are looking at the bus routes for chapel hill. it is important that buses arrive on time...
Questions
question
Chemistry, 07.10.2021 21:40
Questions on the website: 13722360