subject
Engineering, 23.10.2019 22:30 chmereaustin1

Wasted hot air (considered as an ideal gases) with a temperature of 627 o c (state 1), flows at 2.0 kg/s through an adiabatic heat exchanger (which is a closed heat exchanger & no mixing), leaving at 377 o c (state 2). it exchanges heat with the stream of water entering at 7 bars and h3=697.22 kj/kg (state 3), assuming each line flow steadily, and negligible of kinetic and potential energy changes. solve and answer both case i and case ii. (all sub-questions are 4 points, except 6 points of each sketch). t (k) = t(o c)+273. case a only

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
Wasted hot air (considered as an ideal gases) with a temperature of 627 o c (state 1), flows at 2.0...
Questions
question
Mathematics, 28.08.2019 18:40
Questions on the website: 13722367