Engineering, 24.10.2019 01:00 crazylife77

Asecurity administrator wants to implement two-factor authentication for network switches and routers. the solution should integrate with the company’s radius server, which is used for authentication to the network infrastructure devices. the security administrator implements the following: an hotp service is installed on the radius server. a security administrator wants to implement two-factor authentication for network switches and routers. the solution should integrate with the company's radius server, which is used for authentication to the network infrastructure devices. the security administrator implements the following:

an hotp service is installed on the radius server.

the radius server is configured to require the hotp service for authentication.

the configuration is successfully tested using a software supplicant and enforced across all network devices. network administrators report they are unable to log onto the network devices because they are not being prompted for the second factor.

which of the following should be implemented to best resolve the issue?

(a) replace the password requirement with the second factor. network administrators will enter their username and then enter the token in place of their password in the password field.
(b) configure the radius server to accept the second factor appended to the password. network administrators will enter a password followed by their token in the password field.
(c) reconfigure network devices to prompt for username, password, and a token. network administrators will enter their username and password, and then they will enter the token.
(d) install a totp service on the radius server in addition to the hotp service. use the hotp on older devices that do not support two-factor authentication. network administrators will use a web portal to log onto these devices.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

You know the right answer?

Asecurity administrator wants to implement two-factor authentication for network switches and router...

Questions