Engineering, 28.10.2019 21:31 manyah6189

An industrial sewing machine (having mass m) is mounted on springs (with stiffness k) and dampers (with damping coefficient b) to decrease the force transmitted to the floor. the input force acting on the sewing machine during operation is denoted by f(t), while the vertical motion of the machine is denoted by y(t). the sewing machine mass is 150 kg. suitable spring and damper values must be selected so that the vertical motion of the machine is sufficiently small

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

You know the right answer?

An industrial sewing machine (having mass m) is mounted on springs (with stiffness k) and dampers (w...

Questions