Engineering, 28.10.2019 22:31 gedntrxAa

Circular copper rods of diameter d=1mm and length l=25mm areused to enhance heat transfer from a surface that is maintained atts,1=100 deg. c. one end of the rod is attached tothis surface (at x=o), hile the other end (at x=25mm) is joined toa second surface that is maintained at ts,2=0deg. c. air flowing between the surfaces (and over the rods)is also at a temperature t? = 0 deg. c, and has a convectioncoefficient of h=100 w/m2kelvin.

a. what is the rate of heat transfer by convection from a singlecopper rod to air?
b. what is the total rate of heat transfer from a 1 m x 1 m section of the surface at 100 deg. c, if a bundle of the rods is installed on 4-mm centers?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

Circular copper rods of diameter d=1mm and length l=25mm areused to enhance heat transfer from a sur...

Questions