Engineering, 30.10.2019 06:31 bqg464

2. a hot tub manufacturer wants the thermostat to control water temperature to within one degree when set at 130 degrees fahrenheit. they randomly select 10 hot tubs, set the thermostats to 130, and record the following data with an infrared thermometer that has recently been calibrated. temp 129.9 129.7 130.2 129.7 129.8 130 129.6 131 130.3 129.8 a. using the data above, determine whether the hot tub manufacturer is meeting its temperature control standard? (12points) b. what is the process capability index? (4points) c. what precision statement can you make from part "a and b" (2point) 3. using the data in question 2, what precision statement would you make @ 99.7% confidence if the process is in control. (14points

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

You know the right answer?

2. a hot tub manufacturer wants the thermostat to control water temperature to within one degree whe...

Questions