Engineering, 30.10.2019 22:31 isyssjones42

We wish to analyze the velocity (v) of a fluid exiting an orifice in the side of a pressurized tank. the tank contains a fluid to a depth ( h ) above the orifice. the air above the fluid in the tank is pressurized to a value of ( p ). we realize the greater the pressure inside, the greater the velocity. we also believe the greater the depth of fluid, the greater the velocity. examine the equations below and indicate for each if the equation is a valid or invalid equation; justify your answer for each case. in these expressions, g is the acceleration due to gravity and r is the fluid density.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The proportional limit is always greater than the yield strength for a material. a)-trune b)- false

Answers: 3

Answer

You know the right answer?

We wish to analyze the velocity (v) of a fluid exiting an orifice in the side of a pressurized tank....

Questions