subject
Engineering, 31.10.2019 00:31 kayleeblanton1132

Afuel oil is fed to a furnace and burned with 30.0% excess air. the oil contains 87.0 wt% c, 10.0% h, and 3.00% s. analysis of the furnace exhaust gas shows only n2, o2, co2, so2, and h2o. the sulfur dioxide emission rate is to be controlled by passing the exhaust gas through a scrubber in which most of the so2 is absorbed in an alkaline solution. the gases leaving the scrubber (all of the n2, o2, and co2, and some of the h2o and so2 entering the unit) pass out to a stack. the scrubber has a limited capacity, however, so that a fraction of the furnace exhaust gas must be bypassed directly to the stack. at one point during the operation of the process, the scrubber removes 95.0% of the so2 in the gas fed to it, and the combined stack gas contains 634.5 ppm (parts per million) so2 on a dry basis; that is, every million moles of dry stack gas (i. e. not including the water) contains 634.5 moles of so2. we wish to calculate the fraction of the exhaust bypassing the scrubber at that moment.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
Afuel oil is fed to a furnace and burned with 30.0% excess air. the oil contains 87.0 wt% c, 10.0% h...
Questions
question
History, 16.04.2020 19:29
question
Social Studies, 16.04.2020 19:29
Questions on the website: 13722363