subject
Engineering, 31.10.2019 00:31 b2cutie456

On january 9, 2014, 10,000 gallons of crude mchm (75% pure, density=0.9074 g/cm3) was spilled into the elk river in wv, which is tributary to the ohio river (assume the spill occurred instantaneously). estimate the mchm concentration profile at the greater cincinnati water works intake 310 km downriver. the river had a flow of q=3,350 m3/s during the spill, the average river width is 400 m, average depth is 14 m, the average slope is 8x10-5 m/m and a rectangular cross section can be assumed. assume mchm is conservative (not reactive) in this environment. how does the mchm concentration profile you calculate compare to the actual concentration of about 20?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
You know the right answer?
On january 9, 2014, 10,000 gallons of crude mchm (75% pure, density=0.9074 g/cm3) was spilled into t...
Questions
question
Mathematics, 15.07.2020 19:01
question
Mathematics, 15.07.2020 19:01
question
Computers and Technology, 15.07.2020 19:01
Questions on the website: 13722361