Engineering, 01.11.2019 04:31 rina62

Amold has a downsprue length = 6.0 in. the cross sectional area at the bottom of the sprue is 0.5 in2. the sprue leads into a horizontal runner which feeds the mold cavity, whose volume = 75 in3. determine (a) velocity of the molten metal flowing through the base of the downsprue, (b) volume rate of flow, and (c) time required to fill the mold cavity.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

You know the right answer?

Amold has a downsprue length = 6.0 in. the cross sectional area at the bottom of the sprue is 0.5 in...

Questions