Engineering, 02.11.2019 05:31 pookie879

An adiabatic air compressor is to be powered by a direct coupled adiabatic steam turbine that is also driving a generator. steam enters the turbine at 12.5 mpa and 500-degree c at a rate of 25 kg/s and exits at 10 kpa and a quality (or dryness factor) of 0.92. air enters the compressor at 98 kpa and 295 k at a rate of 10 kg/s and exits at 1 mpa and 620 k. determine the net power delivered to the generator by the turbine.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

You know the right answer?

An adiabatic air compressor is to be powered by a direct coupled adiabatic steam turbine that is als...

Questions