subject
Engineering, 07.11.2019 00:31 rakanmadi87

In this lab you will write a backtracking algorithm to solve a simple puzzle that is

similar to sudoku. in "simpledoku" you have to fill an empty square grid of n x n

cells, with each cell getting one of the digits 1 through n. a number may not be

repeated in any row, in any column, in the long top-left-to-bottom-right diagonal, or

in the long top-right-to-bottom-left diagonal. try it on paper first. you’ll find that the

4x4 puzzle is very easy, but things get harder as the grid gets bigger. many students

report the 6x6 is harder than they expected, but 7x7 is easier than 6x6.

assignment:

1) create an enum, called evaluation, that defines 3 constants:

accept, abandon, and continue (just like the example in

lecture).

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
In this lab you will write a backtracking algorithm to solve a simple puzzle that is

sim...
Questions
question
Social Studies, 23.09.2019 22:50
question
Mathematics, 23.09.2019 22:50
Questions on the website: 13722361