Engineering, 07.11.2019 03:31 BrownBeauty4623

Astrain gauge that has a nominal resistance of 350 w and a gauge factor of 1.8 is mounted in an equal-arm wheatstone bridge (equal-arm means that the other 3 resistors also have a 350 w resistance. these 3 resistors are not strain gauges). this strain gauge is mounted to sense axial strain. the bridge output voltage is 1 mv and the input voltage is 5 v. what is the axial strain measured by the strain gauge? if we also have strain in the transverse direction (perpendicular to the axial direction) and this strain is 15% of the axial one, what is the error in the previous axial strain due to a transverse sensitivity of the gauge of 0.05? the gauge factor of 1.8 was obtained from a tensile test on a steel specimen (poisson’s ratio = 0.27).

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

You know the right answer?

Astrain gauge that has a nominal resistance of 350 w and a gauge factor of 1.8 is mounted in an equa...

Questions