subject
Engineering, 07.11.2019 03:31 jeff2852

Candidates for promotion at a city police department are required to take a written aptitude test. scores on this test are normally distributed with a mean of 230 and a standard deviation of 50. a random sample of 9 test scores was taken. (a)what is the standard error of the sample mean score? (b)what is the probability that the sample mean score is less than 210? (c)what is the probability that the sample mean score is more than 245? (d)suppose that the population standard deviation is, in fact, 30, rather than 50. without doing the calculations, state how this would change your answers to parts (a), (b), and (c). illustrate your conclusions with the appropriate graphs.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 Β°f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 06.07.2019 03:10
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
question
Engineering, 06.07.2019 04:30
Mention two examples each of the direct and indirect measurement of force.
Answers: 3
You know the right answer?
Candidates for promotion at a city police department are required to take a written aptitude test. s...
Questions
question
Chemistry, 25.11.2021 06:40
Questions on the website: 13722362