Engineering, 07.11.2019 05:31 walkereddie580
Asheet metal manufacturer is making 10-gauge sheet metal, which is supposed to be 3.416 mm thick. one of the pieces of manufacturing equipment was suspected of malfunctioning, so the manufacturer tested a random sample of 100 pieces of steel to make sure the average steel thickness is 3.416 mm. which of the following is a statement of the null hypothesis? the equipment is not working properly. the average average steel thickness is not 3.416 mm. the equipment is working properly. the average average steel thickness is 3.416 mm. the equipment is making the sheet metal too thick. the average average steel thickness is greater than 3.416 mm.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Fluids at rest possess no flow energy. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 19:20
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
You know the right answer?
Asheet metal manufacturer is making 10-gauge sheet metal, which is supposed to be 3.416 mm thick. on...
Questions
Chemistry, 13.11.2020 08:10
Chemistry, 13.11.2020 08:10
Chemistry, 13.11.2020 08:10
Mathematics, 13.11.2020 08:10
Mathematics, 13.11.2020 08:10
Mathematics, 13.11.2020 08:10
Mathematics, 13.11.2020 08:10
