Engineering, 08.11.2019 18:31 Lizzyloves8910

For the value of kp = 0.2 and given a unit step reference input, use gcl(s) to obtain the controlled output θ(s). next, using the poles of θ(s), provide the formulation of θ(t) as a function of time. do not compute the residues. (d) for each value of controller gain kp = 0.2, 0.5, 1.0, 2.0, obtain the response of the closed-loop output θ(t) given that the reference is a unit step input. you can use the step command for this purpose, or build the model in simulink. superimpose the responses to be able to compare the time scales. how does a change in kp influence the response? briefly explain.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

You know the right answer?

For the value of kp = 0.2 and given a unit step reference input, use gcl(s) to obtain the controlle...

Questions