Engineering, 09.11.2019 00:31 kelebsessoms89

The velocity profile in fully developed laminar flow in a circular pipe of inner radius r = 7 cm, in m/s, is given by u(r) = 4 (1 − r2r2). determine the average and maximum velocities in the pipe and the volume flow rate. (round the final answers of the velocities to two decimal places and the final answer of the volume flow rate to five decimal places.)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

You know the right answer?

The velocity profile in fully developed laminar flow in a circular pipe of inner radius r = 7 cm, in...

Questions