Engineering, 12.11.2019 23:31 karlyisaunicorn

Cite the phases that are present and the phase compositions for the following alloys: (a) 90 wt% zn—lo wt% cu at 400°c (750°f)(b) 75 wt% sn-25 wt% pb at 175°c (345°f)(c) 55 wt% ag-45 wt% cu at 900°c (1650°f)(d) 30 wt% pb-70 wt% mg at 425°c (795°f)(e) 2.12 kg zn and 1.88 kg cu at 500°c (930°f)(f) 37 lbm pb and 6.5 lbm mg at 400°c (750°f)(9) 8.2 mol ni and 4.3 mol cu at 1250°c (2280°f)(h) 4.5 mol sn and 0.45 mol pb at 200°c (390°f)

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

You know the right answer?

Cite the phases that are present and the phase compositions for the following alloys: (a) 90 wt% zn—...

Questions