Engineering, 14.11.2019 03:31 hannahkharel2

The fatigue data for a ductile cast iron are given as follows: stress amplitude [mpa (ksi)] cycles to failure 248 (36.0) 1 × 105 236 (34.2) 3 × 105 224 (32.5) 1 × 106 213 (30.9) 3 × 106 201 (29.1) 1 × 107 193 (28.0) 3 × 107 193 (28.0) 1 × 108 193 (28.0) 3 × 108
(a) make an s–n plot (stress amplitude versus logarithm cycles to failure) using these data.
(b) what is the fatigue limit for this alloy?
(c) determine fatigue lifetimes at stress amplitudes of 230 mpa (33,500 psi) and 175 mpa (25,000 psi).
(d) estimate fatigue strengths at 2 × 105 and 6 × 106 cycles.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

Answer

Engineering, 06.07.2019 04:30

At steady state, air enters an insulated duct of varying cross-sectional area (similar to a nozzle or diffuser) at 200 kpa, 52°c with a mass flow rate of 0.5 kg/s. at the duct exit, the pressure of the air is 100 kpa, the velocity is 255 m/s, and the cross-sectional area is 2 x 10-3 m^2. assuming an ideal gas model, determine: a)-find the specific volume of the air at the exit, in m3/kg. b)- the temperature of the air at the exit, in k. c)-the velocity of the air at the inlet, in m/s. d)-the inlet cross-sectional area, in m^2.

Answers: 1

Answer

You know the right answer?

The fatigue data for a ductile cast iron are given as follows: stress amplitude [mpa (ksi)] cycles...

Questions