Engineering, 15.11.2019 21:31 xlameweirdox

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reached. however, the flow can be tripped to a turbulent state by adding roughness to the leading edge of the plate. for a particular situation, experimental results show that the local heat transfer coefficients for laminar and turbulent conditions are:
h lam ( x ) = 1.74 w / m^ 1.5 * k x^ − 0.5
h turb ( x ) = 3.98 w / m^ 1.8 * k x ^− 0.2
calculate the average heat transfer coefficients for laminar and turbulent conditions for plates of length l = 0.1 m and 1 m.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Prove the equivalence between the two statements of the 2nd law of thermodynamics (i.e., a violation of one statement leads to the violatio the other statement)

Answers: 2

Answer

Engineering, 06.07.2019 03:20

1kg of water contained in a piston-cylinder assembly undergoes two processes in series from an initial state where the pressure is 3.0 bar and the temperature is 150°c process 1-2: the water is compressed isothermally to a volume of 0.25 m^3 with 120 kj of work being done to the system. process 2-3: the water is heated at constant volume to a final pressure of 10 bar. a. find the change in internal energy for the system. b. calculate the amount of heat transferred, in kj. c. sketch both processes on a t-v diagram. (196.33 kj/kg, 76.33 kj)

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump

Answers: 2

Answer

You know the right answer?

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reac...

Questions