subject
Engineering, 15.11.2019 22:31 tatipop49

Problem 13 design a light dimmer circuit that will control a 100w 120vac incandescent lamp where the lamp is completely on when a dc control voltage is 5v, completely off when the dc control voltage is 0v, and that continuously varies in intensity from completely off to completely on as the control voltage is varied between 0v and 5v. you may assume thyristors with the specifications given below are available for your design.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
question
Engineering, 04.07.2019 18:20
Vibration monitoring this technique uses the noise or vibration created by mechanical equipment and in seme cases by plant systems to detemine their actual condtion. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Problem 13 design a light dimmer circuit that will control a 100w 120vac incandescent lamp where the...
Questions
Questions on the website: 13722359