subject
Engineering, 19.11.2019 07:31 jstringe424

If an organization must evaluate the following three information assets for risk management, which vulnerability should be evaluated first for additional safety controls? which should be evaluated last? ·switch l47 connects a network to the internet. it has two vulnerabilities: it is susceptible to hardware failure at a likelihood of 0.2, and it is subject to an snmp buffer overflow attack at a likelihood of 0.1. this switch has an impact rating of 90 and has no current controls in place. you are 75% certain of the assumptions and data. ·server websrv6 hosts a company web site and performs e-commerce transactions. it has a web server version that can be attacked by sending it invalid unicode values. the likelihood of that attack is estimated at 0.1. the server has been assigned an impact value of 100, and a control has been implanted that reduces the impact of vulnerability by 75%. you are 80% certain of the assumptions and data. ·operators use an mgmt45 control console to monitor operations in the server room. it has no passwords and is susceptible to unlogged misuse by the operators. estimates show the likelihood of the misuse is 0.1. there are no controls in place on this asset; it has an impact rating of 5. you are 90% certain of the assumptions and data.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
If an organization must evaluate the following three information assets for risk management, which v...
Questions
question
Mathematics, 02.03.2021 22:40
question
French, 02.03.2021 22:40
question
Mathematics, 02.03.2021 22:40
Questions on the website: 13722360