subject
Engineering, 19.11.2019 23:31 solphiafischer

Two 2.30 cm × 2.30 cm plates that form a parallel-plate capacitor are charged to ± 0.708 nc . part a what is the electric field strength inside the capacitor if the spacing between the plates is 1.00 mm ? express your answer with the appropriate units. e e = nothing nothing submitrequest answer part b what is potential difference across the capacitor if the spacing between the plates is 1.00 mm ? express your answer with the appropriate units. v v = nothing nothing submitrequest answer part c what is the electric field strength inside the capacitor if the spacing between the plates is 2.00 mm ? express your answer with the appropriate units. e e = nothing nothing submitrequest answer part d what is the potential difference across the capacitor if the spacing between the plates is 2.00 mm ? express your answer with the appropriate units. v v = nothing nothing submitrequest answer provide feedback next

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
You know the right answer?
Two 2.30 cm × 2.30 cm plates that form a parallel-plate capacitor are charged to ± 0.708 nc . part a...
Questions
question
Mathematics, 23.11.2020 23:00
question
Mathematics, 23.11.2020 23:00
question
Social Studies, 23.11.2020 23:00
question
Mathematics, 23.11.2020 23:00
question
Mathematics, 23.11.2020 23:00
Questions on the website: 13722362