subject
Engineering, 20.11.2019 23:31 RyannLambertt7141

Two carts of mass ma and mb are free to roll on a straight horizontal track. initially, the velocities of the carts are vai ˆı and vbi ˆı, with vai > vbi. because of this last inequality, the two carts will collide. the coefficient of restitution for the collision is e1. given ma, mb, vai, vbi, and e, find the horizontal components of velocity, vaf , vbf after impact.2. for each set of parameter values listed below, calculate numerical values for final velocity components vaf and vbf , as well as kinetic energy before impact and kinetic energy after impact. what percentage of the initial kinetic energy is lost during the impact? (a) ma = 1 mg, mb = 5 mg, vai = 10 m/s, vbi = 0, e = 0.5.(b) ma = 5 mg, mb = 1 mg, vai = 10 m/s, vbi = 0, e = 0.5.(c) ma = 5 mg, mb = 1 mg, vai = 10 m/s, vbi = 0, e = 1.0.(d) ma = 3 mg, mb = 3 mg, vai = 10 m/s, vbi = 0, e = 1.0.(e) ma = 4 mg, mb = 3 mg, vai = 10 m/s, vbi = 5 m/s, e = 1.0.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:20
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 04.07.2019 19:10
What is the main objective of using reheat rankine cycle?
Answers: 3
You know the right answer?
Two carts of mass ma and mb are free to roll on a straight horizontal track. initially, the velociti...
Questions
question
Mathematics, 07.01.2021 04:00
question
Mathematics, 07.01.2021 04:00
question
Mathematics, 07.01.2021 04:00
Questions on the website: 13722362