subject
Engineering, 21.11.2019 20:31 alexisscalera7

Let x[n] = cos(17 pi n/64) + 2 sin(23 pi n/32) for 0 less than or equal to n less than or equal to 255, and 0 otherwise. the signal x[n] is passed through an lti system with transfer function h(z) = (1 - 1/2z^-1)(1 - 1/3z^-1). denote the signal at the output of the system by y[n]. we want to recover rr[n] by passing y[n] through an inverse system. (a) find (analytically) an impulse response g[n] of the inverse system, g(z) = 1/h(z). (b) apply a rectangular window of length m = 8, w[n] = {1 0 less than or equal to n less than or equal to 7, 0 otherwise, to obtain an fir filter r[n] = g[n]. w[n]. using matlab, plot the frequency response of the fir filter (useful command: fft). compare it (on the same graph) with the frequency response of the iir inverse system (useful command: freqz). is m = 8 an appropriate choice? (c) compute x^[n] = r[n] * y[n]. plot x[n], y[n], and x^[n] - x[n]. (you may use command subplot(2, 2, -) to plot all graphs in a single figure.)

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
question
Engineering, 04.07.2019 19:10
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
You know the right answer?
Let x[n] = cos(17 pi n/64) + 2 sin(23 pi n/32) for 0 less than or equal to n less than or equal to 2...
Questions
question
Mathematics, 15.01.2021 20:10
question
Mathematics, 15.01.2021 20:10
Questions on the website: 13722367