Engineering, 25.11.2019 19:31 squawk1738

Along, cylindrical, electrical heating element of diameter d = 10 mm, thermal conductivity k = 240 w/m-k, density rho = 2700 kg/m^3, and specific heat c_p = 900 j/kgk is installed in a duct for which air moves in cross flow over the heater at a temperature and velocity of 27 degree c and 10 m/s, respectively.

a. neglecting radiation, estimate the steady state surface temperature when, per unit length of the heater, electrical energy is being dissipated at a rate of 1000 w/m.

b. if the heater is activated from an initial temperature of 27 degree c, estimate the time required for the surface temperature to come within 10 degree c of the steady state value.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

You know the right answer?

Along, cylindrical, electrical heating element of diameter d = 10 mm, thermal conductivity k = 240 w...

Questions