Engineering, 26.11.2019 01:31 cmcdonnell8812

Apitot tube is used to measure air speed in an experimental setup similar to your "flow over a flat plate" experiment with an atmospheric pressure of 100 kpa. if the measured gage pressure is recorded as 3.7 cm of water, obtain: (a) the air speed. assume a density of 1.206 kg/m 3 for air and a density of 992 kg/m 3 for water. enter your answer in meters per second (m/s).

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

Apitot tube is used to measure air speed in an experimental setup similar to your "flow over a flat...

Questions