Engineering, 26.11.2019 03:31 araminaara691
Two strain gauges are mounted so that they sense axial strain on a steel member in uniaxial tension. the 120 v gauges form two legs of a wheatstone bridge, and are mounted on opposite arms (e. g., arms 1 and 4). the gauge factor for each of the strain gauges is 2 and e m for this steel is 29 ã 106 psi. for a bridge excitation voltage of 4 v and a bridge output voltage of 120 î¼v under load (i. e., ei = 4 v and 0 ï¤ e =120 î¼v ): (a) estimate the maximum strain.(b) what is the resistance change experienced by each gauge?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
Engineering, 06.07.2019 04:10
Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump
Answers: 2
Engineering, 06.07.2019 04:10
Steam enters a converging-diverging nozzle at 1.0 mpa and 500°c with a negligible velocity at a mass flow rate of 2.5 kg/s, and it exits at a pressure of 200 kpa. assuming the flow through the nozzle to be isentropic, determine: the exit area and (a) (b) the exit mach number
Answers: 2
You know the right answer?
Two strain gauges are mounted so that they sense axial strain on a steel member in uniaxial tension....
Questions
Spanish, 31.03.2020 22:44
Mathematics, 31.03.2020 22:44
Mathematics, 31.03.2020 22:44
Mathematics, 31.03.2020 22:44
Mathematics, 31.03.2020 22:44
Social Studies, 31.03.2020 22:44
Physics, 31.03.2020 22:44
Mathematics, 31.03.2020 22:44
Mathematics, 31.03.2020 22:44
