Engineering, 26.11.2019 06:31 alexiasommers41
1) do the gain, slew rate, cutoff frequency, and unity gain frequency of an op amp change with the circuit it is used in? when these same parameters are examined for an op amp amplifier circuit from the input of the circuit to the output, do they change with the circuit used, i. e, do parameters like unity-gain frequency, cutoff frequency, etc. differ for inverting and non-inverting amplifiers? 2) why does an op amp show a gain/phase change with frequency?
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
You know the right answer?
1) do the gain, slew rate, cutoff frequency, and unity gain frequency of an op amp change with the c...
Questions
Chemistry, 07.08.2019 21:10
Mathematics, 07.08.2019 21:10
English, 07.08.2019 21:10
Physics, 07.08.2019 21:10
Computers and Technology, 07.08.2019 21:10
