subject
Engineering, 26.11.2019 17:31 cobyontiveros

The defroster of an automobile functions by discharging warm air on the inner surface of the windshield. to prevent condensation of water vapor on the surface, the temperature of the air and the surface convection coefficient (t_infinity) must be large enough to maintain a surface temperature t that is at least as high as the dewpoint consider a windshield of length l = 800 mm and thickness f 6 mm and driving conditions for which the vehicle moves at a velocity of v = 70 mph in ambient air from laboratory experiments performed on a model of the vehicle, the average convection coefficient on the outer surface of the windshield is known to be correlated by an expression of the form n_ul = 0.030 where rel properties of the ambient air may be approximated as k what is the smallest value of h, required to prevent condensation on the inner surface?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26Β°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70Β°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
The defroster of an automobile functions by discharging warm air on the inner surface of the windshi...
Questions
question
Mathematics, 02.10.2019 14:50
Questions on the website: 13722360