Engineering, 26.11.2019 19:31 Delgadojacky0206

An air conditioner operating at steady state takes in moist air at 28oc, 1 bar, and 70% relative humidity. the moist air first passes over a cooling coil in the dehumidifier unit and some water vapor is condensed. the rate of heat transfer between the moist air and the cooling coil is 11 tons. saturated moist air and condensate streams exit the dehumidifier unit at the same temperature. the moist air then passes through a heating unit, exiting at 24oc, 1 bar, and 40% relative humidity. neglecting kinetic and potential energy effects, determine:

(a) the temperature of the moist air exiting the dehumidifier unit.
(b) the volumetric flow rate of the air entering the air conditioner, in m3/min.
(c) the rate water is condensed, in kg/min.
(d) the rate of heat transfer to the air passing through the heating unit, in kj/min.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

You know the right answer?

An air conditioner operating at steady state takes in moist air at 28oc, 1 bar, and 70% relative hum...

Questions