To use the method of superposition to calculate a beam defection and slope.
for beams with sm...
Engineering, 26.11.2019 20:31 Dmgirl123
To use the method of superposition to calculate a beam defection and slope.
for beams with small deflections, the assumptions for using the method of superposition apply: the deflections and slopes are linearly related to the load, and the deflections do not significantly change the original geometry of the beam.
the deflections and slopes for beams subjected to multiple loads can then be found using linear combinations of known results for individual loads.
use the two loadings below and the principle of superposition to answer the following questions.
determine the load combination a beam is subjected to the loading shown where w_a = 2 kn/m and w_b = 2.8 kn/m .
describe the loading as a linear combination of the loads in the above table.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
Engineering, 04.07.2019 19:10
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
You know the right answer?
Questions
Mathematics, 20.04.2020 20:55
Mathematics, 20.04.2020 20:55
Mathematics, 20.04.2020 20:55
Chemistry, 20.04.2020 20:55
Mathematics, 20.04.2020 20:55
Chemistry, 20.04.2020 20:55
Mathematics, 20.04.2020 20:55
