Engineering, 27.11.2019 05:31 loveuncondition

The disk rolls without slipping on the horizontal surface as shown . the disk has a clockwise angular velocity of 20 rad/s and a counterclockwise angular acceleration of 5 rad/s^2 at the instant under consideration .the value of r is 200mm and the angle between ab and ob is given as 19.11degree .pin a is fixed to the disk but slides freely within the slotted member bc. determine the velocity and acceleration of pin a relative to the slotted member bc and the angular velocity and angular acceleration of bc. neglect the distance from the center of pin a to the edge of disk.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

You know the right answer?

The disk rolls without slipping on the horizontal surface as shown . the disk has a clockwise angula...

Questions