Engineering, 27.11.2019 19:31 CrusaderLord

Problem 1if the a-36 steel pipe has an outer diameter of 30 mm and inner diameter of 20 mm, determine the factor of safety against yielding of the material at point a according to the a) maximum-shear-stress theory b) maximum-distortion-energy theoryc) if instead this pipe were made from a brittle, high carbon steel, then determine the factor of safety against yielding for the material at point a using the brittle mohr coulombe (bcm) theory (carbon addition can increase the brittleness of steel). in this case, use tensile strength, σyt= 896 mpa and compressive strength, σyc = 2160 mpa (from matweb).note: we suggest re-working this problem for practice, but you can start this problem with stresses that you determined for the two square stress elements solved for in hw 6.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Apure substance is a)-mixture of various chemical elements or compounds b)-substance that has a fixed chemical composition throughout c)-mixture that is homogeneous (such as air) d)-all the answers

Answers: 3

Answer

You know the right answer?

Problem 1if the a-36 steel pipe has an outer diameter of 30 mm and inner diameter of 20 mm, determin...

Questions