Engineering, 30.11.2019 00:31 lamwil9432

Abalanced bank of delta-connected capacitors is connected in parallel with the load described in assessment problemthe effect is to place a capacitor in parallel with the load in each phase. the line voltage at the terminals of the load thusremains at 2450 v. the circuit is operating at a frequency of 60 hz. the capacitors are adjusted so that the magnitude ofthe line current feeding the parallel combination of the load and capacitor bank is at its minimum. a) what is the size of each capacitor in microfarads? b) repeat (a) for wye-connected capacitorsc) what is the magnitude of the line current? problemthe magnitude of the line voltage at the terminals of a balanced y-connected load is 6600 v. the load impedance is 240 —170 ﬂ/¢. the load is fed from a line that has an impedance of 0.5 + i4 q/¢,a) what is the magnitude of the line current? b) what is the magnitude of the line voltage at the source?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

You know the right answer?

Abalanced bank of delta-connected capacitors is connected in parallel with the load described in ass...

Questions