subject
Engineering, 30.11.2019 06:31 airbenderjermai

There is a proposal in brooklyn to construct a new mid-rise apartment building on a vacant lot at the intersection of avenue a and 48th street. the property is square, providing flexibility for the location of the building and an associated playground. the developer wishes to locate a small park and playground adjacent to the quietist street. the traffic volumes for avenue a are: cars – 496; medium trucks – 52, heavy trucks – 19; and buses - 10. the traffic volumes for 48th street are: cars – 822; medium trucks – 22, heavy trucks – 8; and buses - 3. following his thinking, which street should the park be adjacent to? (3 points) assuming the setbacks are the same, what is the difference in noise levels adjacent to the 2 streets? (4 points) based upon people’s perceptions of noise differences, are the developer’s concerns valid? why? (3 points)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
question
Engineering, 04.07.2019 19:10
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
There is a proposal in brooklyn to construct a new mid-rise apartment building on a vacant lot at th...
Questions
question
Mathematics, 22.09.2019 20:20
question
Mathematics, 22.09.2019 20:20
Questions on the website: 13722363