Engineering, 03.12.2019 04:31 saniyawilliams1207
Ahelical compression spring is to be made of oil-tempered wire of 4-mm diameter with a spring index of c = 10. the spring is to operate inside a hole, so buckling is not a problem and the ends can be left plain. the free length of the spring should be 80 mm. a force of 50 n should deflect the spring 15 mm. determine the spring rate. determine the minimum hole diameter for the spring to operate in. determine the total number of coils needed. determine the solid length. determine a static factor of safety based on the yielding of the spring if it is compressed to its solid length.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Engineering, 04.07.2019 19:10
Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.
Answers: 1
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
You know the right answer?
Ahelical compression spring is to be made of oil-tempered wire of 4-mm diameter with a spring index...
Questions
Mathematics, 14.04.2020 03:49
Social Studies, 14.04.2020 03:49
Mathematics, 14.04.2020 03:49
Mathematics, 14.04.2020 03:49
Biology, 14.04.2020 03:49
Mathematics, 14.04.2020 03:49
Mathematics, 14.04.2020 03:49
English, 14.04.2020 03:49
