subject
Engineering, 03.12.2019 20:31 drinkingfood

Washington and jefferson inc.’s board of directors has decided to repurchase some of its stock on the open market because it wants to increase the company’s debt-to-equity ratio. what is the company’s motivation for the stock repurchase? to acquire shares needed for employee options or compensation to protect against a takeover attempt to adjust the firm’s capital structure to distribute excess funds to stockholders which of the following statements would be considered advantages of a stock repurchase? check all that apply. the interval between stock repurchases tends to be irregular, which means that investors cannot always count on cash inflows from repurchases. stock repurchases allow a firm to distribute earnings to investors without changing the amount of the regular cash dividend. a stock repurchase can be used to minimize the dilution effect associated with employees exercising their stock options. grade it now save & continue continue without saving

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
You know the right answer?
Washington and jefferson inc.’s board of directors has decided to repurchase some of its stock on th...
Questions
question
Geography, 02.02.2021 18:30
question
History, 02.02.2021 18:30
question
Mathematics, 02.02.2021 18:30
question
Mathematics, 02.02.2021 18:30
question
History, 02.02.2021 18:30
question
Mathematics, 02.02.2021 18:30
question
Mathematics, 02.02.2021 18:30
question
History, 02.02.2021 18:30
question
Mathematics, 02.02.2021 18:30
question
Mathematics, 02.02.2021 18:30
Questions on the website: 13722367