Engineering, 05.12.2019 03:31 QueenNerdy889

Avapor mixture of n-butane (b) and n-hexane (h) contains 50.0 mole% butane at 120 °c and 1 atm. a stream of this mixture flowing at a rate of 150.0 l/s is cooled and compressed, causing some but not all of the vapor to condense. (treat this process as a single-unit operation.) liquid and vapor product streams emerge from the process in equilibrium at t (°c) and 1100 mmhg. the vapor product contains 60.0 mole% butane. determine: a)the required final temperature (t) b)the composition of the liquid product (component mole fractions) c)the molar flow rates of the liquid and vapor products.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

You know the right answer?

Avapor mixture of n-butane (b) and n-hexane (h) contains 50.0 mole% butane at 120 °c and 1 atm. a st...

Questions