Engineering, 06.12.2019 00:31 jameskatzfeystu70

Consider a simple gas turbine power plant. air enters the compressor at 30°c and 100 kpa (state 1) with a mass flow rate of 12.6 kg/s and exits at 260°c and 700 kpa (state 2). a fuel with a heating value of 42,000 kj/kg is burned in the combustion chamber with an air-fuel ratio of 60 and a combustion efficiency of 97%. product gases (modeled as air) enter the turbine (state 3) and expand to 100 kpa (state 4). isentropic efficiency of the turbine is 85%. assume constant specific heats at 500°c for air.
(a) calculate the isentropic efficiency of the compressor, in %.
(b) determine the net power output, in kw.
(c) find thermal efficiency of the cycle, in %.
(d) what is the exergetic efficiency of the cycle, in %?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

You know the right answer?

Consider a simple gas turbine power plant. air enters the compressor at 30°c and 100 kpa (state 1) w...

Questions