Engineering, 06.12.2019 04:31 meredith48034

Pure aluminum is poured into a sand mold. the metal level in the pouring basin is 4.5 in. above the metal level in the mold, and the runner is circular with a 0.25 in diameter. the viscosity of the metal is 1.5e-07 lb-s/in2 and its density is 0.098 ib/in3 g 32.2 fsec 2
a) calculate the velocity of the metal when it gets into the mold.
b) calculate the flow rate of the metal when it gets into the mold.
c) calculate the reynolds number (re velocitydiameterdensity/viscosity )

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.

Answers: 1

Answer

You know the right answer?

Pure aluminum is poured into a sand mold. the metal level in the pouring basin is 4.5 in. above the...

Questions

SAT, 01.09.2021 01:40

Who wants more? because here you go ...