Engineering, 06.12.2019 19:31 shelbs6632

In this exercise, we will examine how replacement policies affect miss rate. assume a two-way set associative cache with four one-word blocks. consider the following word address sequence: 0, 1, 2, 3, 4, 2, 3, 4, 5, 6, 7, 0, 1, 2, 3, 4, 5, 6, 7, 0. consider the following address sequence: 0, 2, 4, 8, 10, 12, 14, 16, 0
5.20.3 [5] < §§5.4, 5.8> simulate a random replacement policy by flipping a coin. for example, "heads" means to evict the first block in a set and "tails" means to evict the second block in a set. how many hits does this address sequence exhibit?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

In this exercise, we will examine how replacement policies affect miss rate. assume a two-way set as...

Questions