Engineering, 12.12.2019 04:31 Joshghopper

Home depot. you donít have a pickup truck (nor does your friend), but you do have a roof rack with cross bars on your car. so you will have to secure the plywood to the roof rack in order to get it home. your friend (the one who does not have a pickup truck) suggests that you tie the plywood on sideways (so that the short edge is front to back) and drive at about 13 mph. use standard sea-level conditions = 0: 002369 slugs/ft3 and = 3: 7372 107 slugs (a) estimate the drag on the plywood for the case suggested by your friend. (b) estimate the drag on the plywood if you turn the sheet so that the long edge is front to back. (c) explain why your friend suggested the sideways configuration.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

You know the right answer?

Home depot. you donít have a pickup truck (nor does your friend), but you do have a roof rack with c...

Questions